Due to COVID-19, we are experiencing a slight delay in shipping and customer service inquiries on all orders. Our team is working diligently to ensure your order is shipped out as soon as possible. We greatly appreciate your patience and understanding.


Your Cart is Empty

Sublimation Ceramic Car Coaster-2 1/2" Gloss


Supplies needed:
- sublimatable substrate (coaster)
- sublimation transfer
- teflon or scratch paper
- heat tape
- soft paper towel (optional)

Heat press settings:
- temperature - 400 degrees F
- dwell time - 1:00 - 1:15 minutes
- pressure - light

- Settings will vary depending on the heat press brand and model ink and
paper and atmospheric conditions.
- The layers of soft paper towel achieve two goals: 1. it helps to distribute
the pressure evenly throughout the substrate; 2. it helps to trap ink that is
dispersed outside of the edges of the substrate if there is an overprint area
or full bleed in the artwork.

Layer the press from the bottom pad to the top heat platen as follows:
1. teflon sheet or scratch paper
2. 2-3 layers of soft paper towel
3. substrate
4. transfer
5. teflon sheet or scratch paper

1. Position the substrate (coaster) onto the transfer.
2. Tape the substrate to the transfer using the heat tape.
3. Place the transfer and substrate in the press onto the paper towel
(transfer on top of substrate).
4. Place the teflon sheet or scratch paper over the transfer.
5. Press the items using the settings listed above.
6. Remove items from the press immediately. Use heat resistant gloves if
necessary - the items will be very hot.

- If the image of the final product appears too light increase the pressure
or the dwell time slightly (5-15 seconds).
- If the image on the final product appears blurred or substrate appears
yellowed reduce the dwell time slightly (5-15 seconds).